Wentworth Technology SpeedTHRU Operations Instructions download pdf (Page 17)

Wentworth Technology, Inc. www.wentworthtechnology.com 877.495.1634

Battery Installation:

The battery compartment is located on the opposite side of the headset from the microphone boom.

To open the battery compartment, push up on the battery door latch while pulling out the bottom of

the door. Insert the battery with the label facing out. Replace the door by inserting the top of the door

in its slot followed by pushing the bottom of the door into place until it locks.

Battery Low Alert:

When a battery reaches a low level of charge a “Low Battery” prompt will sound. The Battery Low

Alert will sound reminders once every 30 seconds for about 2 minutes until the battery is replaced.

If ignored the headset will either automatically power off or turn the boom LED solid red and disable

button presses depending on the headset version you are using. . Ample time is provided from the

rst alert until the headset shuts down (1 hr +). headsets will monitor the battery level and when it

gets consistently low, it will play the “LOW BATTERY” message 4 times (30 seconds apart) and then

play “HEADSET OFF”, turn the boom LED solid red, and disable the button presses.

Battery Charging:

Place the battery in one of the charging ports on the battery charger. The lights will communicate the

charging or ready status of the battery. Battery charging time is approximately 4

hours. Only remove batteries from the charger when the light is green, indicating a

full charge. Only charge depleted batteries. For example, do not charge batteries at

the end of each shift.

Either a 3-bay or 6 bay battery charger is part of this sytem.

3-Bay: Insert batteries with label to the right. A red light will display if the battery

needs charging. A green light indicates a fully charged battery.

6-Bay: Insert batteries with the label away from the latch. A ashing amber

battery indicates a pending charge. An amber light indicates a charging battery. A

solid green light indicates a fully charged battery.

It is recommended that 6-bay chargers be wall mounted to reduce the likelihood of liquids,

or debris falling into the charger. The lights must be on the right side, which will place

the retention latches under each battery. Also run the power supply cord behind the wall

mounted charger to prevent accidential unplugging.

battery door latch

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24

No comments

Wentworth Technology SpeedTHRU Operations Instructions Page 17